V4-V5 FlexCam

The Ventura V4/V5 FlexCam is the fastest solution for the economical and precise production of medium and large series of parts with a diameter of up to 5 mm (maximum in mild steel), from Coil stock.

This machine is the evolution of the V2 FlexCam equipped with a 3-station turret, including:

• 1 counter-collet spindle
• 2 boring spindles

The station change is carried out in 1/4" by a Geneva drive. Locking is carried out via a pilot punch with an axis parallel to that of the spindles, but placed on a larger radius. This technique guarantees positioning accuracy.

The Ventura FlexCam system enables individual optimization of operational parameters. The possibility of programming the cam shaft speed per segment increases the performance of the cam machines. E.g. it is possible to slow the feed during sectioning and to increase it while turning. Thanks to this technology, overall cycle time is no longer determined by the slowest process. In addition, spindle and straightener speeds can be adjusted throughout the entire program (no more changing pulleys; plus significant improvement in quality of the parts produced, both as to tolerances and surface finish).

Types of uses

• Simple parts
• Coil stock
• Material diameter up to 5 mm (maximum in mild steel)
• Very short production cycles
• Two-tool turning operations
• Front-end machining with 2 tools
• Non-stop 24-h production
• Easy start-up
• Easy production process adaptation